This product is a point-to-point multi-service optical transmission device that is developed on the basis of the special-purpose VLSI developed by the company.
This product is a point-to-point multi-service optical transmission device that is developed on the basis of the special-purpose VLSI developed by the company. This product provides 8 channels of 3Gbps HD-SDI video, 8 channels of telephone interfaces; 8 channels of digital interfaces/4 channels of RS232-422-485 interfaces; 4 channels of Fast Ethernet interfaces, 2 channels of Gigabit Ethernet interface. 3Gbps HD-SDI high-definition digital TV optical transceiver signal format from 270Mbps to 2.97Gbps, supports SMPTE424M, SMPTE292, SMPTE344M, SMPTE259M, and DVB-ASI (270M) and other digital TV format signals.
Each Ethernet electrical port has its own independent 100M bandwidth; the total bandwidth of the 6-channel Ethernet is 2*1000M+4*100M=2400M, which is completely independent and physically isolated through an optical fiber transmission; the internal circuit part of the device adopts a full digital Circuit, the whole machine works reliably and stably, low power consumption, high integration, small size, easy installation, and maintenance.
● SD, HD, 3G input automatic detection, support 270Mbit/s – 1.48Gbit/s – 3Gbit/s rate; support the new FULL HD full HD 1080P/60HZ 3Gbps HD-SDI format signal, transmission distance up to 80KM; Support SMPTE 424M(2.97Gbps/s), SMPTE 292M(1.485Gbps/s), SMPTE 344M(540Mb/s), SMPTE 259M(360Mb/s) and DVB-ASI(270Mb/s);M(1.485Gbps/s)、SMPTE 344M(540Mb/s)、SMPTE 259M(360Mb/s)和 DVB-ASI(270Mb/s);
● With automatic cable equalization in the transmitter, 80M: 2.97Gb/s, 140M: 1.485Gb/s 250M: 270Mb/s;
● Both the transmitter and receiver have LEDs to indicate the access status of the SDI signal
● 4 channels 100M Ethernet ports work in 100M full-duplex mode, each Ethernet electrical port has its own independent 100M bandwidth and is physically isolated;
● 2 channels Gigabit Ethernet 10/100/1000M, full/half duplex fully self-adaptive, each group has an independent 1000M bandwidth, physical isolation;
● 100M Ethernet supports the transmission of VLAN super-long data packets, which can be matched with switch products supporting IEEE802.1Q protocol, and can support jumbo-frame Ethernet packets with a maximum packet length of 10240;
● 1-8 channels of voice access, support caller ID function/reverse polarity billing/fax function; voice port supports FXO/FXS/24-wire EM/24-wire audio/magnet phone interface, FXO port is connected to the program-controlled switch , the FXS port is connected to the user’s telephone;
● It can be connected to 1-8 switches or 1-4 RS232/422/485 serial interfaces;
● 1 Console management interface (optional); 1 SNMP management interface (optional);
● Various interfaces from radar protection to IEC61000-4-5 (10/700μS) Differential mode: 6KV impedance (40Ω); Common mode: 6KV, impedance (40Ω) standard;
● A variety of power supply modes are available: AC220V, DC-48V/DC24V, etc.; support AC+DC; AC+AC; DC+DC and other dual power supply modes;
Optical port: 1
Optical fiber: single fiber double fiber
Optical interface: FC/SC/ST/LC(SFP)
Wavelength: 850nm/1310nm multimode; 1310nm/1550nm single mode
Transmission distance without relay: 20~120Km
Typical transmit power:
Single mode 1310/1550nm: ≥-9dBm
Multimode 850nm: -18dBm
Multimode 1310nm: -25dBm
Acceptance sensitivity range: -28dBm~-
Video Bandwidth: 270Mb/s – 2.97Gb/s
TV signal standards: SMPTE 424M, SMPTE 292M, SMPTE 344M, SMPTE 259M and DVB-ASI
Reflection loss: >15DB
Equalization: 250m@270Mbit/s, 140m@1.485Gbit/s, 80m@2.97Gbit/s
Interface: 75 ohm BNC
Protocol: Compliant with IEEE 802.3, IEEE 802.1Q (VLAN)
Rate: 10/100M adaptive, full/half duplex fully adaptive
MAC address table: 4096 MAC addresses can be learned
Physical interface: RJ45 support Auto-MDIX
Ringing Voltage: 75V
Ringing frequency: 25Hz
Two-wire input impedance: 600Ω (off-hook)
Return loss: 20dB
Ringing detection voltage: 35V
Ringing detection frequency: 17Hz-60Hz
Two-wire input impedance: 600Ω (off-hook)
Return loss: 20 dB
standard
EIA/TIA-232 RS-232 (ITU-T V.28)
EIA/TIA-422 RS-422 (ITU-T V.11)
EIA/TIA-485 RS-485 (ISO/IEC8284)
Serial interface:
RS-422: TxD+ TxD- RxD+ RxD-
RS-485 4 wires: TxD+ TxD- RxD+ RxD-
RS-485 2 wires: A (corresponding to TX+) B (corresponding to TX-) Ground
RS-232: RXD TXD Signal Ground
Output interface type: Signal relay dry contact output
Response time: Signal relay dry contact output: <1.2ms
Switch signal: Signal relay dry contact output 36VDC/0.5A
Maximum switching frequency: 50HZ
System power supply: AC180V～260V; DC–48V; DC+24V
(support dual power redundancy backup)
Power consumption: ≤10W
● Environmental Indicators
working temperature: -10 ℃ – +60 ℃
Storage temperature: -40 ℃ – +85 ℃
Working humidity: 0% -95% ( no condensation)
MTBF: > 100,000 hours
Product Number |
FCP-V4G2O8K8 |
Function Description |
Simultaneously transmit 8 channels of 3G HD-SDI video on optical fiber, 1-8 channels of telephone interfaces; 1-8 channels of digital interfaces/1-4 channels of RS232-422-485 interfaces; 2 channels of Gigabit Ethernet (physical isolation), 4-channel Fast Ethernet (physical isolation) |
Port Description |
1-8 channels of 3G HD-SDI video, 1-8 channels of telephone interfaces; 1-8 channels of digital interfaces/1-4 channels of RS232-422-485 interfaces, 2 channels of Gigabit Ethernet, 4 channels of Fast Ethernet, 1 optical fiber interface, 1 console interface, 1 SNMP interface |
Power |
AC220V / DC-48V / DC+24V (power supply optional) |
Size |
(L×W×H) 485*200*45mm 19 inch 1U rack mount |
Weight |
3.8Kg / pc |
If you are interested in any product, please contact us. We will introduce our products to you in more detail
Online Message
Get a Quote
